Removal Of The Swingarm - Ducati SUPERBIKE 848 MY 2008 Manual

Rear swingarm
Operation
Refit the rear brake caliper
Refit the rear sprocket
Refit the rear wheel
Tension the drive chain as indicated in the paragraph

Removal of the swingarm

Before removing the parts in question, you must first carry out the following operations:
Operation
Remove the rear wheel
Remove the rear sprocket
Remove the rear brake caliper
Remove the shock absorber and tie-
rod from the swingarm
Remove the rear hub as described in
Free the rear brake hose from the lower chain slider (8) and the speed sensor wiring by unscrewing the bolts (9).
Disconnect the speed sensor wiring connector (A) from the main wiring loom.
You can check the play in the swingarm bearings while the swingarm (4) still installed on the motorcycle frame
Grasp the rear of the swingarm (4) and try to move it in the four directions shown by the arrows.
file:///C|/848/wsm/en/848_08_G_5_8_00.36.1.html (7 of 15) [11-6-2008 0:34:32]
Section reference
G 6, Refitting the rear brake caliper
G 8, Refitting the rear sprocket
G 4, Refitting the rear wheel
Section reference
G 4, Removal of the rear wheel
G 8, Renewal of the rear sprocket
G 6, Removal of the rear brake caliper
G 7, Removal of the rear suspension
rocker arm
Removal of the rear wheel eccentric hub and rear wheel axle
WWW.PlanDeGraissage.ORG
Adjusting the chain tension , in Sect. D 4.
in this section.