Rear swingarm
Remove the other washer (14).
Withdraw the eccentric hub (17) from the chain side of the swingarm.
Notes
The rear hub is a component particularly critical to the dynamic safety of the motorcycle. For this reason, any
overhaul of the internal components of the hub is strictly forbidden. The hub is available as complete assembly, part
no. 819.2.042.1A.
Refitting the rear wheel eccentric hub and rear wheel axle
Refitting is the reverse of removal, with attention to the following points.
If the caliper bracket locating pin (2) was removed, apply the recommended threadlocker on reassembly.
Before refitting, apply the recommended grease to the seat on the eccentric hub (17) of the caliper mounting bracket
(16) on which the rings (15), also greased, will be located. Position the mounting bracket (16) so that the point
indicated is aligned with the anti-rotation pin (2).
file:///C|/848/wsm/en/848_08_G_5_8_00.36.1.html (4 of 15) [11-6-2008 0:34:32]
WWW.PlanDeGraissage.ORG