Seat
seat cowling and side panels
Refitting the seats
Refitting the rider seat
Position the seat (1) on the bike pushing it against the fuel tank so that the front catches engage the corresponding
locations on the fuel tank.
Fit the washers (3) on the bolts (2) and fit them in the rear slots of the seat (1) to secure it to the rear subframe.
Tighten the bolts (2) to the specified torque (Sect. C 3,
Refitting the pillion seat
Refit the pillion seat (4) and fit the catches on the seat base under the frame cross tube.
Press down on the pillion seat until you hear the catch engage with an audible click.
Make sure that the pillion seat (4) is fully engaged by lightly pulling it upwards.
file:///C|/848/wsm/en/848_08_E_3_4_00.23.1.html (13 of 14) [11-6-2008 0:34:26]
WWW.PlanDeGraissage.ORG
Frame torque
settings).