Ducati SUPERBIKE 848 MY 2008 Manual page 262

Rear swingarm
To install the ball bearing races (19) you will need service tool no. 88713.2409 comprised of:
(A) drift for internal bearings;
(A) drift for external bearings;
(C) guide pin.
Fit a new bearing (19) with the internal spacer (20) onto the drift (A) and position it on the interior of the right-hand
side support of the swingarm.
Insert the guide pin (C) into the previously mounted roller bearings and insert the other end in the bore in the tool
(A).
Drive the bearing (19) fully into the swingarm.
Fit the other new bearing (19) at the outer end of tool (A).
Using tool (A) as a stop, use tool (B) to drive the external bearing up against spacer (20): remove the tools.
Before refitting the swingarm (4), grease the ball bearings (19), roller bearings (25) and seal rings (23) with the
recommended grease.
file:///C|/848/wsm/en/848_08_G_5_8_00.36.1.html (12 of 15) [11-6-2008 0:34:32]
WWW.PlanDeGraissage.ORG