Checking The Engine Oil Pressure - Ducati SUPERBIKE 848 MY 2008 Manual

Diagnostic instruments
To adjust the balance, turn the bypass screws (20) and (21) until the two lines on the graph coincide, if in graphic
mode, or until identical numerical values are displayed, if in numerical mode.
Correct balancing is obtained when the two lines of the graph are superimposed or when the two numerical values
indicated are equal.

Checking the engine oil pressure

Notes
The on-screen icons used during this procedure are explained in a table at the end of this section.
To measure the pressure of the lubrication circuit, use the engine oil pressure test point (19) as follows:
Remove the right-hand side fairing (Sect. E 2,
Disconnect the wiring connector (A) and remove the pressure switch (19), taking care to recover the seal.
file:///C|/848/wsm/en/848_08_D_5_5_00.19.1.html (21 of 47) [11-6-2008 0:34:24]
Removal of the side
WWW.PlanDeGraissage.ORG
fairings).