Fuel tank
Removal of the fuel filler cap assembly
Open the filler cap.
Unscrew the outer bolts (9) securing the ring nut to the filler cap recess.
Unscrew the anti-theft screw (8) on the inside.
Remove the complete filler cap assembly.
The rubber breather nozzle (B) is located inside the filler cap. If the nozzle (B) is to be renewed, apply a uniform film
of speed bonder around the groove.
Fit the rubber making sure that it is properly seated in the recess groove.
Refitting the fuel filler cap assembly
Grease the new O-ring and its groove in the fuel tank.
Refit the filler cap assembly in its seat in the tank and tighten the bolts (8) and (9) to the specified torque (Sect. C 3,
Frame torque
settings).
file:///C|/848/wsm/en/848_08_L2_10_00.48.1.html (4 of 12) [11-6-2008 0:34:37]
WWW.PlanDeGraissage.ORG