Refitting The Gearchange Mechanism - Ducati SUPERBIKE 848 MY 2008 Manual

Gearchange mechanism
components.
If the bush (2) inside the pedal (1) needs replacing, drive the new bush into place using a press. The bush must be
seated 2 mm below the outer face of the pedal.
Warning
After working on the gearchange mechanism, check the position of the gear pedal.
To adjust the position of the gear pedal, follow the instructions provided in Sect. D 4,
gearchange and rear brake

Refitting the gearchange mechanism

To refit the gearchange mechanism, reverse the operations of the removal procedure.
In particular, grease the O-rings (6), apply threadlocker to the bolt (13), pivot bolt (5) and bolt (17) and then tighten
them to the specified torque (Sect. C 3,
Operation
Refit the left-hand fairing
1
file:///C|/848/wsm/en/848_08_F_05_6_00.30.1.html (3 of 3) [11-6-2008 0:34:29]
pedals.
Frame torque
Section reference
E 2, Refitting the side fairings
WWW.PlanDeGraissage.ORG
settings).
Adjusting the position of the