Ducati SUPERBIKE 848 MY 2008 Manual page 551

Gearbox assembly: gearchange mechanism
Refitting the gear interlock plunger and pawl assembly
On the special bolt (3), fit the gear pawl lever (4), orienting it as shown in the figure, the washer (2) with the square
edge side (D) facing the clutch-side crankcase, and the spring (1), positioning it so that the hook end (A) is facing the
gear pawl lever. Locate the hook end (A) of the spring on the gear pawl lever as shown in the figure.
Apply threadlocker to the bolt thread. Start the bolt in the crankcase half. Position end (B) of the spring so that it
rests against rib (C) of the crankcase half, as shown in the figure. Tighten the bolt (3) to the specified torque
(Sect. C 3, Engine torque
file:///C|/848/wsm/en/848_08_N_7A9_00.71.1.html (5 of 8) [11-6-2008 0:34:51]
settings). Check that the spring functions correctly by manually moving the gear pawl lever.
WWW.PlanDeGraissage.ORG