Connecting The Gps Smart Antenna To The 8010-Sie-Gps Ii; Figure 2-5: Pole Mounting The Smart Antenna - evertz 8010-SIE Instruction Manual

Model 8010-SIE Digital Source ID Encoder Manual

Figure 2-5: Pole Mounting the Smart Antenna

2.9.2. Connecting the GPS Smart Antenna to the 8010-SIE-GPS II

A standard 50 foot long interface cable (Evertz part WA-T09) is provided with the 8010-SIE-GPS II and
the smart antenna. One end of this cable is fitted with a weather-tight 12 pin Molex connector. The
other end is fitted with a 9 pin male subminiature D connector and should be connected to the SERIAL
I/O connector on the rear panel of the 8010-SIE-GPS II. The pin out of the cable is shown in Figure
2-6. If you require a longer cable, a 100 foot (Evertz part WA-T76) or 400 foot cable (Evertz part WA-
T11) may be ordered from the factory. Custom length weatherproof cables can also be special ordered.
Alternately, you can wire a 9 pin Extender cable as shown in Figure 2-7.
Connect the interface cable to the smart antenna. The connector on the interface connector has a
locking ring for securing the connection.
INSTALLATION Page 2-10
Revision 2.2