Table of Contents
Advertisement
Pin
Table 2-2: Serial Control Pin Definitions - RS-422 Controller Configuration
On the 8010-SIE-GPSII this port is configured at the factory for connection to the GPS antenna. If you
need to upload firmware to the 8010-SIE-GPSII you will have to reconfigure the port to its RS-232
configuration as described in section 5.2.2. Table 2-3 shows the pinout of the serial port in its GPS
antenna configuration.
Pin
Table 2-3: Serial Control Pin Definitions – GPS Antenna Configuration
2.1.6. Parallel Remote Control Connections
PARALLEL: A 9 pin D connector located on the rear panel labeled PARALLEL provides 6 parallel
control inputs for remote control of some of the model 8010-SIE functions. There are also
two open collector outputs that can be assigned to a variety of functions. See section 2.6 for
information on connecting the parallel inputs and outputs and section 3.8.5 for a complete
description of the operation of the Parallel I/O functions. The pinout of the PARALLEL
connector is as follows:
INSTALLATION
Name
#
1
GND
Chassis ground
2
Rx-
Receive A (Rx-) Input
3
Tx+
Transmit B (Tx+) Output
4
Tx Gnd
Transmit Signal Ground
5
Spare
Not connected
6
Rx Gnd
Receive Signal Ground
7
Rx+
Receive B (Rx+) Input
8
Tx-
Transmit A (Tx-) Output
9
GND
Chassis ground
Name
#
1
GND
Chassis ground
2
Tx-
Transmit A (Tx-) Output
3
Rx+
Receive B (Rx+) Input
4
PPS+
1 PPS Interrupt in +
5
+12V
+12 Volts DC out
6
PPS-
1 PPS Interrupt in -
7
Tx+
Transmit B (Tx+) Output
8
Rx-
Receive A (Rx-) Input
9
GND
Chassis ground
Model 8010-SIE Digital Source ID Encoder Manual
Description
Description
Revision 2.2
Page 2-3
Advertisement
Table of Contents
