Configuring The Output Audio Channel Sources; Setting Gain For Each Audio Channel - evertz 7700 Manual

7700 MultiFrame Manual
7710XUC-HD HD Format Up/Down/Cross Converter

6.9.1. Configuring the Output Audio Channel Sources

There are eight controls that select the source of the eight audio channels being processed. For the sake
of brevity, only the selection control for channel 1 will be included in this manual.
Audio Proc
Output Channel 1
Input channel 1
Input channel 2
Input channel 3
Input channel 4
Input channel 5
Input channel 6
Input channel 7
Input channel 8
Mono mix 1 & 2
Mono mix 3 & 4
Mono mix 5 & 6
Mono mix 7 & 8
Mute

6.9.2. Setting Gain for Each Audio Channel

There are eight controls that set the gain of the eight audio channels being processed. For the sake of
brevity, only the gain control for input channel 1 will be included in this manual.
Audio Proc
Input Channel 1 Gain
0 dB
-24dB to 24dB
7710XUC-HD
-40
This control selects the source of audio for the output channel 1. The output
can be taken from any of the input channels or a mono mix of pairs. The
output can also be muted.
The default is that the input channel will be the same as the output channel
(i.e. output channel 1 will come from input channel 1).
The audio gain controls are used to adjust the level of the respective input
audio channel. The gain controls have a range of +/-24 dB with 1/10 dB
resolution. The displayed value is the amount of gain (positive), or
attenuation (negative), in decibels, where 0dB corresponds to unity gain.
Revision 1.0