Configuring The Serial Port; Figure 5-1: Jumper Settings For Serial Port Configurations - evertz 8010-SIE Instruction Manual

Model 8010-SIE Digital Source ID Encoder Manual

5.2.2. Configuring the Serial Port

The Serial port can be configured for various pinouts, as described in Chapter 2. During manufacture,
the serial port or a model 8010-SIE is configured for RS-232 DCE and the serial port of a model
8010-SIE-GPSII is configured for the GPS antenna.
To reconfigure the serial port it is necessary to unplug the Source ID encoder and remove the top
cover. Figure 5-1 shows the settings of jumper block J9 on the main circuit board for the various
configurations available. The pinouts corresponding to RS-232 DCE, RS-422 controller and GPS
configurations are given in Chapter 2. It is impossible to tell whether the serial port pinout has been
altered without opening the unit for inspection.
RS-422 RS-422 GPS
RS-232 DCE RS-232 DTE
CONTROLLER ANTENNA
TRIBUTARY

Figure 5-1: Jumper Settings for Serial Port Configurations

TECHNICAL DESCRIPTION Page 5-3
Revision 2.2