Setting The Sdi Vertical Interval Blanking; Setting The Ntsc Setup Pedestal On The Monitor Analog Output; Downloading New Character Fonts; Testing The Ram - evertz 8010-SIE Instruction Manual

3.8.12. Setting the SDI Vertical Interval Blanking

SDI VBLANK END
Vbl end line 06
Vbl end line 22
Vbl end line 10
Vbl end line 20

3.8.13. Setting the NTSC Setup Pedestal on the Monitor Analog Output

NTSC SETUP
NTSC setup on
NTSC setup off
No setup in PAL

3.8.14. Downloading New Character Fonts

FONT DOWNLOAD
Shift+sel=start

3.8.15. Testing the RAM

XRAM TEST
Xram test on ?
OPERATION
Model 8010-SIE Digital Source ID Encoder Manual
The SDI VBLANK END menu item is used determine where the V bit in
the SDI TRS will be set to zero (indicating vertical blanking). If the V
blank bit is zero on a higher line number than the VITC is placed on,
some devices may discard the VITC.
For 525 systems the normal setting is for the vertical blanking to end at
line 10. If this causes problems with downstream devices, it can be set
to end at line 20, however some devices may blank the VITC if it is
placed prior to line 20.
For 625 systems, the normal setting is for the vertical interval to end at
line 6. If this causes problems with downstream devices, it can be set
to end at line 23, however some devices may blank the VITC if it is
placed prior to line 20.
The NTSC SETUP menu item is used to determine how the NTSC
Setup Pedestal will be applied on the Monitor Analog Output. The
NTSC setup pedestal should not be present when operating in Japan.
Select NTSC setup on to apply the Setup pedestal to all lines of the
active picture.
Select NTSC setup off to remove the NTSC Setup Pedestal from all
lines.
The FONT DOWNLOAD menu item is used to change the character
inserter font. For more information about uploading new font files see
section 5.4.
The XRAM TEST menu item is used to initiate a test of the Character
RAM.
Revision 2.2
Page 3-27