Adjusting The General Purpose Output Duration - evertz 8010-SIE Instruction Manual

GPO1 ASSIGNMENT
Gpo1 = rdr event
Gpo1 = gen event
Gpo1 = gps@ event
Gpo1 = 1 pulse/sec
Gpo1 = 1 pulse/min
Gpo1 = ref failure
Gpo1 = gps failure

3.8.7.3. Adjusting the General Purpose Output Duration

GPO DURATION
Gpo duration 01
OPERATION
Model 8010-SIE Digital Source ID Encoder Manual
The following descriptions indicate the how the GPO will function with
each setting.
Rdr event The output will activate when the reader time matches
the REVT register and the event register is armed. See section
3.8.7.3 for information about setting the REVT register and
arming it.
Gen event The output will activate when the generator time
matches the GEVT register and the event register is armed.
See section 3.8.7.3 for information about setting the GEVT
register and arming it.
1 pulse/sec The output will activate at the beginning of each second
of the generator time.
1 pulse/min The output will activate at the beginning of each minute
of the generator time.
Ref failure The output will activate when a proper Gen Lock video
reference is missing.
The following two functions for the General purpose outputs are only
available on the 8010-SIE-GPSII model.
Gps@ event The output will activate when the generator time
matches the GPS@ register and the event register is armed.
This is the time that the Generator will be resynchronizes to the
GPS antenna time. See section 3.9.4 for information about
setting the GPS@ register and arming it.
Gps failure The output will activate when communications to the
GPS Receiver is missing.
The GPO DURATION menu item is used to adjust the duration (in
frames) of the general purpose outputs. Use the
change the duration
.
Revision 2.2
keys to
OR
Page 3-24