Table of Contents
Advertisement
Pin
#
1
2
3
4
5
6
7
8
9
2.1.7. Power Connections
LINE:
The 8010-SIE was manufactured with two different power suply configurations. Earlier
versions may be set for either 115v/60 Hz or 230v/50 Hz AC operation.
selector switch is accessible on the rear panel. The line voltage connector contains an
integral slow blow fuse (and a spare one).
The 8010-SIE-GPS II and later versions of the 8010-SIE have a universal power supply
operating on either 115v/60 Hz or 230v/50 Hz AC operation.
2.2.
MOUNTING
The 8010-SIE Digital Source ID Encoder is equipped with rack mounting angles and fits into a standard
19 inch by 1 3/4 inch (483 mm x 45 mm) rack space. The mounting angles may be removed if rack
mounting is not desired.
2.3.
POWER REQUIREMENTS
2.3.1. Power Requirements – Early versions of Model 8010-SIE
2.3.1.1. Selecting the Correct Mains Voltage
Power requirements are 115 or 230 volts AC at 50 or 60 Hz, switch selectable on the rear panel.
Power should be applied by connecting a 3 wire grounding type power supply cord to the power entry
module on the rear panel. The power cord should be minimum 18 AWG wire size, type SST marked
VW-1, maximum 2.5 m in length.
Before connecting the line power, be sure to select the proper line voltage. Also,
check that the line fuse is rated for the correct value marked on the rear panel.
INSTALLATION
Model 8010-SIE Digital Source ID Encoder Manual
Name
GPO 1
General Purpose Output 1
GPO 2
General Purpose Output 2
GPI 1
General Purpose Input 1
GPI 2
General Purpose Input 2
JAM Ena
Jam Sync enable (8010-SIE)
Sync GPS
Resync to GPS Time (8010-SIE-GPSII)
Bypass
Enable Bypass Relay
VCG Ena
VCG On/Off
VITC Ena
VITC reader enable
GND
Frame ground
Table 2-4: Parallel Remote Control Pin Definitions
Revision 2.2
Description
The voltage
Page 2-4
Advertisement
Table of Contents
