Table of Contents
Advertisement
16. Press '1' to initiate X-modem file transfer of the font information.
17. The boot code will prompt you to confirm that you want to erase the Flash ROM memory. Press 'Y'
to proceed, 'N' to cancel.
The Flash ROM must be erased first.
18. The boot code will indicate when the Flash memory is erased
Flash ROM is now BLANK. You may proceed.
19. Upload the character font "*.HEX" file supplied using the X-Modem transfer protocol of your terminal
program. If you do not start the upload within a short time the font loading operation will time out.
You can restart the process by selecting '1' from the menu again.
20. The boot code will indicate whether the operation was successful upon completion of the upload.
Download Complete!
21. The following is a list of possible reasons for a failed file transfer:
•
The supplied "*.HEX" file is corrupt.
•
You pressed 'X' to upload a Firmware file instead of '1' to upload a font file
•
Wrong file specified to be uploaded.
•
The PCs' RS-232 communications port can't handle a port speed of 19200 baud.
22. To complete the font upgrade power-down the unit and reapply power without pressing any keys to
resume normal operation. If the Flash ROM contains valid code, the unit will resume normal
operations. If there is a problem in the new font file, you will be prompted with an error message
and remain in the bootloader.
23. If you changed jumpers at the beginning of this procedure return the jumpers to their original
positions.
TECHNICAL DESCRIPTION
Model 8010-SIE Digital Source ID Encoder Manual
Proceed (Y/N)
Revision 2.2
Page 5-8
Advertisement
Table of Contents
