Table of Contents
Advertisement
Edit Controller
Lance HSE-100
Figure 2-3: Connection of 8010-SIE in Eavesdropping Mode
Edit Controller
RS422 Controller port
Description
Frame Ground
Receive A (Rx-)
Transmit B (Tx+)
Transmit Gnd
Spare
Receive Gnd
Receive B (Rx+)
Transmit A (Tx-)
Frame Gnd
2.8.
CONNECTING TO A PROFILE RS-232 PORT (MODEL 8010-SIE ONLY)When the 8010-SIE is
in the LVS mode, the serial remote control port is used to listen to a serial data stream from the Profile
disk recorder. This serial communication is normally daisy-chained to each of the 8010-SIE units that
are connected on the Profile outputs. The serial port is used to obtain status, LVS and CTL information
from the Profile recorder. (See chapter 4 for a complete description of the serial port operation).
In order to properly address each of the 8010-SIE units connected in the daisy chain, the Profile sends
out an 'address' before each command. The LVS ADDRESS menu item on the Engineering menu of
the 8010-SIE must be set to match the address that the Profile is using for a specific output.
2.9.
GPS ANTENNA INSTALLATION (MODEL 8010-SIE-GPS II ONLY)
The 8010-SIE-GPS II units are designed to work with the Trimble Accutime 2000 Smart Antenna that
can be located up to 1000 feet from the 8010-SIE-GPS II unit. The Smart Antenna houses the GPS
receiver, antenna, power supply and other support circuitry in a sealed, shielded, self-contained unit
with a digital interface to the main unit. The GPS Smart Antenna also receives power from the main
unit through the connection cable.
INSTALLATION
RS422 Tributary port
Pin
Pin
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
Figure 2-4: RS-422 Eavesdrop Cable
Model 8010-SIE Digital Source ID Encoder Manual
SID Encoder
Evertz 8010-SIE
VTR
Serial Port (RS422 Controller)
Description
Frame Ground
Transmit A (Tx-)
Receive B (Rx+)
Receive Gnd
Spare
Transmit Gnd
Transmit B (Tx+)
Receive A (Rx-)
Frame Gnd
Revision 2.2
VTR
Sony DVW-A500P
SID Encoder
Pin
Description
1
Frame Ground
2
Receive A (Rx-)
3
Transmit B (Tx+)
4
Transmit Gnd
5
Spare
6
Receive Gnd
7
Receive B (Rx+)
8
Transmit A (Tx-)
9
Frame Gnd
Page 2-8
Advertisement
Table of Contents
