Turning On The Daylight Saving Time Compensation (8010-Sie-Gps Ii Only); Configuring The General Purpose Inputs And Outputs; Assigning The Functions Of The General Purpose Inputs - evertz 8010-SIE Instruction Manual

3.8.6. Turning on the Daylight Saving Time Compensation (8010-SIE-GPS II ONLY)

DAYLIGHT SAVING
Dst time off
Dst time on

3.8.7. Configuring The General Purpose Inputs and Outputs

A 9 pin D connector located on the rear panel labeled PARALLEL provides 2 general purpose outputs
and 6 general purpose inputs. The pinout of the D connector is shown in Table 2-4
The general purpose outputs can be assigned to several different functions. The outputs will be active
low when the specified condition occurs. The duration of the output is user programmable except
where noted. There are two user programmable general purpose inputs and four dedicated GPI inputs.

3.8.7.1. Assigning the Functions of the General Purpose Inputs

There are four dedicated remote control input pins and two user programmable inputs. The dedicated
input functions are as follows:
VCG ON/OFF Provides an alternate method of turning the character inserter generator On and Off.
The character inserter is toggled On or Off by a high to low transition on this input. This
input has equal priority with the front panel CHAR GEN ON/OFF key.
VITC ENABLE
VITC generator is turned On by a high to low transition on this input, and turned Off by a low
to high transition.
BYPASS When closed to ground this input activates the SDI bypass relay.
GPS SYNC Provides an alternate method of syncing the generator time of the 8010-SIE-GPSII to the
GPS antenna time. Momentarily closing this input to ground and releasing it will perform a
synchronization to the GPS time. (function available on 8010-SIE-GPSII only)
JAM SYNC Provides an alternate method of syncing the generator time of the 8010-SIE's active
reader time when the unit is in TIME SID mode. Momentarily closing this input to ground
and releasing it will perform a synchronization to the reader time. (function available on
8010-SIE only)
OPERATION
Model 8010-SIE Digital Source ID Encoder Manual
The DAYLIGHT SAVING menu item is used to select whether the time
will be compensated for Daylight Saving time or not.
Select Dst time on to compensate for Daylight saving time. This setting
should be used during the period when daylight saving time is in effect.
When this setting is used 1 hour will be subtracted from the Time zone
offset value when the 8010-SIE-GPSII converts between UTC and local
time.
Select Dst time off to turn off compensation for Daylight saving time.
This setting should be used during the period when daylight saving time
is not in effect.
Provides an alternate method of turning the VITC generator On and Off. The
Revision 2.2
Page 3-22