Table of Contents
Advertisement
3.8.8.3. Setting the Serial Port Mode
SERIAL MODE
Serial mode active
Serial mode passive
3.8.9. Adjusting the Front Panel Display Brightness
DISPLAY LEVEL
Display level xx
3.8.10. Turning off the SDI Characters When The Program Source is 'ON AIR' (8010-SIE Only)
ON AIR MODE
On air mode off
On air mode on
3.8.11. Setting the LVS address (8010-SIE Only)
LVS ADDRESS
Lvs Address = xx
OPERATION
Model 8010-SIE Digital Source ID Encoder Manual
The SERIAL MODE menu item is used determine if the 8010-SIE will
passively listen to VTR communications or actively poll the VTR for
time and status information when it is in VTR SID mode.
Select Serial mode active to have the 8010-SIE poll the VTR.
Select Serial mode passive to have the 8010-SIE listen to
communications between the VTR and a controller.
The DISPLAY LEVEL menu item is used to adjust brightness of the
front panel display. Use the
The Characters on the digital program output of the 8010-SIE can be
turned off when the source device is in PLAY or VAR PLAY. This
feature is controlled by the ON AIR menu item. The characters on the
analog output are not affected by the ON AIR menu setting.
Select On air mode on to blank all the Character windows on the digital
program output when the machine Status is Play or VAR, or when the
ON AIR remote control input is closed to ground.
windows on the analog output are not turned off when the machine
status is PLAY or VAR PLAY
When On air mode off is selected, the Character windows on the digital
and analog outputs ignore the VTR Status and the ON AIR remote
control input.
The LVS ADDRESS menu item is used to set up the LVS address that
the 8010-SIE will respond to.
numbers are in the range of 01 to 09.
implemented in the 8010-SIE.
Revision 2.2
and
keys to adjust.
Use the
and
keys to adjust. Valid
LVS Address is not fully
The character
Page 3-26
Advertisement
Table of Contents
