Table of Contents
Advertisement
CAUTION: Over tightening the locking ring can damage the connector on the
smart antenna
Route the interface cable to the location of the 8010-SIE-GPS II unit using the most direct path. Avoid
routing the cable near hot surfaces, sharp or abrasive surfaces, or corrosive fluids or gases. Avoid
sharp kinks or bends in the cable. Additional protection such as heat shrink tubing may be required to
protect the cable jacket at points where the cable enters the building, especially if the opening is rough
or sharp. Once the cable is run, use cable-ties to secure the cable to the pole and to provide strain
relief for the connections. When securing the cable, start at the antenna and work towards the 8010-
SIE-GPS II unit.
Before connecting the cable to the 8010-SIE-GPS II make sure that the jumpers
are set correctly inside the 8010-SIE-GPS II.
jumpers may cause damage to the smart antenna.
correct jumper positions
Power is provided from the 8010-SIE-GPS II along the interface cable to the smart antenna. The
Jumpers located near the Serial I/O D connector on the main circuit card of the 8010-SIE must be in
the correct configuration in order to provide power to the antenna. Your 8010-SIE-GPS II should have
been preset at the factory to this configuration but it is wise to remove the top cover of the unit and
verify the correct orientation of this jumper before proceeding. See section 4.4 for the correct location of
jumpers on the main circuit board.
Trimble antenna
Mini-Con 12 pin
DC Ground
Receive Port (R-)
Transmit Port (T+)
Timing pulse 1pps
DC Power IN
Timing pulse 1pps
Receive Port (R+)
Transmit Port (T-)
Figure 2-6: Accutime 2000 Smart Antenna to 8010-SIE-GPS II Interface Cable
INSTALLATION
Model 8010-SIE Digital Source ID Encoder Manual
(female)
9 ------------------------- 1
2 ------------------------- 2
5 ------------------------- 3
11 ----------------------- 4
1 ------------------------- 5
12 ----------------------- 6
3 ------------------------- 7
4 ------------------------- 8
---------------Drain Wire
(Evertz part WA-T09)
Revision 2.2
Improper configuration of the
Evertz 8010-SIE-GPS II
9 pin "D" style
(male)
Frame Ground
TX A -
RX B +
1 PPS interrupt in +
+12 V DC Unreg.
1 PPS interrupt in -
TX B +
RX A -
Shield
See section 5.2.2 for the
Page 2-11
Advertisement
Table of Contents
