Table of Contents
Advertisement
2. Carefully place the top cover back on the unit before applying power to the unit.
3. With power disconnected, connect the straight through cable between the Source ID encoder serial
port and the PC.
4. Power-up the PC, and start the terminal software.
5. Configure the port settings of the terminal program as follows:
Baud
Parity
Data bits
Stop bits
Flow Control
6. Power up the unit. To upload new font information, use the FONT DOWNLOAD menu item on the
menu. To access the menu item press the SETUP key and use the up or down arrows ( ,
move to the FONT DOWNLOAD menu item.
SHIFT+SELECT keys to start the Font downlaoder
7. The front panel will display the word PROGRAMMER-19200. You should also see a menu appear in
the terminal window on the PC.
For example:
***** Unknown Main Flash Memory Chip *****
*****
Code Bank: 0 1 2 3 4 5 6 7
BLANK?
N N N N N N N N
Flash ROM is NOT valid
***** Intel Char Flash Memory Chip Detected *****
Code Bank: 0 1 2 3 4 5 6 7
BLANK?
N N N Y Y Y Y Y
Flash ROM is valid
-- MENU --------------------------------
<X>Modem download HEX file to Flash
<A>SCII download HEX file to Flash
<1> XModem download of font to Flash
<2> ASCII download of font to Flash
production <T>est (not implemented)
<Q>uit Programmer (Jump into Flash)
----------------------------------------
COMMAND:
15. The following is a list of possible reasons for failed communications:
•
Defective Serial cable.
•
Wrong communications port selected in the terminal program.
•
Improper port settings in the terminal program. (Refer to step 3 for settings).
•
Arrow key ( ) not being pressed correctly during power-up.
TECHNICAL DESCRIPTION
19200
None
8
1
NONE
Cannot Program
Model 8010-SIE Digital Source ID Encoder Manual
Press the SELECT key.
*****
Revision 2.2
) to
Then press the
Page 5-7
Advertisement
Table of Contents
