Table of Contents
Advertisement
The display area consists of a 16 digit alphanumeric display, 6 LED status indicators and a 16
pushbutton keypad.
The keypad is used to program the source ID message that will be encoded, to control the front panel
menu system, to position the character display windows, and to provide control of the front panel
display. When the SHIFT key is held down, the meanings of some of the keys are modified, gaining
quick access to a wider variety of functions. (Throughout this manual SHIFT + indicates that you
should hold down the SHIFT key while pressing the second key.)
A front panel programming menu provides a quick and simple method of configuring the 8010-SIE
Source ID Encoder for your application. Operation of the 8010-SIE and 8010-SIE-GPSII are very
similar. Unless otherwise specified, references to model 8010-SIE include model 8010-SIE-GPS II.
Sections 3.2 to 3.9 give detailed information on the specific operations required to control the 8010-SIE.
3.1.1. The Setup Pushbutton Group
The Setup key group consists of the SELECT, SETUP and
the front panel programming menu system, to position character windows and to enter the source ID
message.
SETUP
Enters the Setup mode that is used to set up various modes of operation. Pressing SETUP
again while in this mode exits the Setup mode. (See also section 3.4)
SHIFT + SETUP Enters the Engineering Setup mode that is used to set up various items that are
normally only required during installation.
SELECT When in the Setup mode the SELECT key is used to activate/deactivate sub menus from
the drop down menu
When in the Setup mode, the
the menu system. (See also section 3.4)
When in the Source ID programming mode, the
between characters in the message and the
characters of the message. (See also section 3.3.)
When in the VCG window select mode, the arrow keys are used to position the individual
character windows on the screen. (See also section 3.7.4.)
When not in the Setup mode, Source ID programming mode or the VCG window select
mode, the arrow keys are used to position all the character windows on the screen. (See
also section 3.7.5.)
OPERATION
Model 8010-SIE Digital Source ID Encoder Manual
,
arrow keys are used to move to various items in
&
&
arrow keys are used to change the
Revision 2.2
,
,
keys and is used to navigate
arrow keys are used to move
Page 3-2
Advertisement
Table of Contents
