Save Calibration Coefficients - NovaStar MX6000 Pro User Manual


Display image: Set the image displayed on the screen. To display the current source image, click and hold

Show locating cursor: When the switch is set to
This helps you quickly locate the cabinets, modules or pixels that you are currently operating.
Enable and Disable Calibration Effect
In the Calibration area, you can turn on or off the sub-calibration switches and then view the display effects before
and after the calibration.
The sub-calibration switches include Brightness and Chroma Calibration, Full-Grayscale Calibration and Low-
Grayscale Calibration. The actual displayed switches depend on the existing coefficient types of the screen.
Figure 4-62 Sub-calibration switches
The main calibration switches are on the Correction and Screen Settings pages. When the main calibration
switches are turned on or off, all the sub-calibration switches will be turned on or off simultaneously.
Figure 4-63 Main calibration switches

4.11.4 Save Calibration Coefficients

Notice
During coefficient saving, if the receiving cards go offline, the saving will fail.
Operating Procedure
Save the calibration coefficients of the current screen, cabinet or module to the receiving card to avoid calibration
effect loss due to power failure.
www.novastar.tech
MX6000 LED Display Controller User Manual
, the selected area on the screen will display blue borders.
.
44