NovaStar MX6000 Pro User Manual page 19

Select a view by clicking one of the following icons at top right of the topology area.

: Show the cabinets only.

: Show the preview image of the input source only.

: Show the cabinets and preview image of the input source at the same time.
Note
You can also select a view from the menu bar > View > Display and choose the content to be displayed, including
cabinet topology, cabinet status, group names, source tags, and overlapping cabinets.
Select a screen.
Select a canvas at the bottom of the page. First click on any output port of the canvas, and then click on the topology
area to place the canvas.
Each canvas corresponds to an output card. For example, the three canvases OUT 1, OUT 2, and OUT 3 in
9 correspond to three output cards respectively.
Figure 4-9 Canvas
Related Operations:

Set canvas resolution: Select a canvas at the bottom of the page and then set the canvas resolution in the
properties area.

Move Canvas: Click and hold the name at the top left of the canvas in the topology area, then drag it to the
desired position.

Delete: Canvas: Click on the name at the top left of the canvas in the topology area to select it, then press
Delete.

Locate Canvas: Set Canvas Mapping to
screen.
After placing a canvas, you can drag or click the mouse in the topology area to add cabinets.
The cabinets will be automatically connected when you are adding them, as shown in
port's load capacity information will be displayed, as shown in
information, as shown in
Figure 4-10 Cabinets connected automatically
www.novastar.tech
, so that the canvas position can be quickly viewed on the LED
Figure 4-12.
MX6000 LED Display Controller User Manual
Figure
Figure 4-11. The properties area will display the cabinet
Figure 4-
4-10. The Ethernet
15