Export Calibration Coefficients - NovaStar MX6000 Pro User Manual

Figure 4-67 Read back coefficients
In the pop-up dialog box, set the relevant parameters and click OK to read the coefficients and apply them to the
screen.

4.11.6 Export Calibration Coefficients

Export the calibration coefficients of the current screen, cabinet or module to the local computer. When the receiving
card is replaced or the new screen has the same specifications, you can upload the exported calibration coefficients
directly to use.
Prerequisites

To export screen coefficients, make sure:
−
The screen configuration is done, the cabinets are not rotated, and there are no cabinet gaps or overlapping.
−
The configured screen must be rectangular, and the top-left-corner coordinates of the circumscribed
rectangle of the configured screen must be (0, 0).

To export cabinet coefficients, make sure:
The target cabinets must have cabinet IDs.
Notice
During coefficient exporting, if the controller and/or receiving cards go offline, the exporting will fail.
Operating Procedure
In the device list on the left, select the desired controller.
From the menu bar, choose Tools > Coefficient Management.
In the Select Mode area, select the export range as needed, including Screen, Cabinet, LDM and Pixel.
Figure 4-68 Select mode
In the Coefficient Management area, click Export.
Select a file path on the pop-up dialog box and click Save.
In the pop-up Export Coefficients window, set the relevant parameters and click OK to export the coefficients of the
screen to a file (.db).
www.novastar.tech
MX6000 LED Display Controller User Manual
46