Table of Contents
Advertisement
Prerequisites
Before the operation, color gamut and brightness correction by using the CA410-VP427, CA410-P427 or EYE2-400
color analyzer must be done.
Operating Procedure
Select the controller from the device list and then select Screen Settings.
In the LED Image Booster section of the Image Quality tab, select an output color gamut from the Gamut drop-
down list.
The output gamut options include standard gamuts, custom gamuts, the original screen gamut and the input gamut
(From input).
To set the custom gamut, click
red, green, blue and white parameters based on the selected gamut. The custom gamut name can be changed.
Drag the slider to adjust color temperature.
Enable or disable Magic Gray as needed.
Figure 4-41 LED Image Booster
4.8.1.3 Apply Calibration Effect
Check the effects before and after screen calibration.
Prerequisites
Before operation, screen calibration must be done and calibration coefficients must be uploaded.
Related Information
When the A10s Pro receiving card is used, the seam correction can be performed separately. This means even if the
calibration switch is turned off, the seam correction effect is still kept.
Operating Procedure
Select the controller from the device list and then select Screen Settings.
In the Image Quality tab, set the Calibration switch to
the calibration platform.
Figure 4-42 Calibration
4.8.1.4 Set Thermal Compensation
Adjust the application intensity of the thermal coefficients.
www.novastar.tech
, select a gamut in the properties area on the color gamut diagram, and adjust the
to make the screen apply the calibration effect made by
MX6000 LED Display Controller User Manual
32
Advertisement
Table of Contents
