Input Source Configuration; Add Layers - NovaStar MX6000 Pro User Manual

4.5 Input Source Configuration

4.5.1 Add Layers

Select the controller from the device list and then select Source.
Figure 4-16 Input source
Select an input card at the bottom of the page.
Double-click the thumbnail of the input source or drag the input source to the target position to add a layer.
(Remember to select a canvas first if there are multiple canvases).
All-In-One Controller supports free layer layout; Send-Only Controller is subject to fixed layer layout and when
adding a layer, it will automatically fill the canvas and the size and position of the layer cannot be adjusted.
You can check the source status according to the source indicator:

Green: The input source is connected.

Red: The input source is applied for the screen but not connected.

Gray: The input source is not connected.
Make layer adjustments as needed.
Lock layer
Switch source
−
Select a layer and select another source in the properties area.
−
Right-click a layer, select Source from the displayed menu, and select another source.
Adjust layer size and position
−
Select a layer and set the layer size and coordinates in the properties area. You can also bring the layer to
front or send it to back.
www.novastar.tech
MX6000 LED Display Controller User Manual
20