Table of Contents
Advertisement
Note: (1) The starting point, pose 1 and pose 2 determine the three reference points of a
complete circle. If the motion path of the robotic arm is a circular arc, then pose 1 and pose 2 are
not necessarily end points or passing points;
(2) If you want the robot arm to change its posture during the movement, set the roll, pitch, and
yaw of pose 2 to the desired posture when completing the trajectory;
【center angle (°) () 】: Indicates the degree of the circle. When it is set
Note: To achieve smooth motion, you need to set Wait = false.
Example explanation:
In this example, the central angle is set to 3600°, which means that the
robotic arm can draw ten circles at a time, and the robotic arm still stays
at the starting point after drawing a circle.
Judgment of the direction of the robotic arm motion
In the above example, the starting point, pose 1 and pose 2 are:
A (300,0,400,180,0,0) B (350,50,400,180,0,0) C (350, -50,400,180,0,0)
⚫ The robotic arm draws a circle in a clockwise direction, and t he
trajectory of the robotic arm is as follows:
circle is determined by current position
and position1 and positon2, "center
angle" specifies how much of the
circle to execute.
to 360, a whole circle can be completed, and it can
be greater than or less than 360;
202
Advertisement
Table of Contents
