Configure Lcn1 With Static Ip Address - Fujitsu 1FINITY L100 User Manual

Initial System Turn Up
Configure IP Connection to DCN
5.6.1

Configure LCN1 with Static IP Address

Prerequisite:
■ If port LCN1 requires a pluggable SFP module, the SFP is installed and its autoprovisioning is complete.
Overview
At the site where the NE is installed, the Local Area Network (LAN) connects to a router and the DCN is reachable
through the router. This section describes the procedure to configure a static IP address on LCN1, configure the
default next-hop IP address, and install a LAN cable connecting LCN1 to the LAN. The LAN cable can connect
directly to a LAN switch port as shown in the following figure.
Virtuora NC
Virtuora User
NETCONF/
Interface
YANG
WebGUI
DCN
CLI
Remote Users
Figure 87
LAN Switch Port Connection
The following figure shows how to save LAN switch ports by connecting the LAN cable to a daisy chain of LAN
cable connections between 1FINITY NEs.
Virtuora NC
Virtuora User
NETCONF/
Interface
YANG
WebGUI
DCN
CLI
Remote Users
Figure 88
Daisy Chain LAN Connection
·
Release 19.1.1 Issue 1.1, May 2021
LAN
Switch
Router
Next-hop IP address
NE Installation Site
LAN
Switch
Router
Next-hop IP address
NE Installation Site
LCN1
1FINITY NE
LAN cable
LCN1
1FINITY NE
LCN2
LCN1
1FINITY NE
LCN2
LCN1
1FINITY NE
LAN cable
170
NE Management
Mode = Bridge
Fujitsu and Fujitsu Customer Use Only