Fujitsu 1FINITY L100 User Manual page 403

System Maintenance
Equipment Replacement
Warning: The blade is heavy. When handling the blade, position two hands in the center at all times.
Moving or lifting the blade with one hand or without assistance (if required) may result in personal injury,
damage to the equipment, or both.
Step 1
If the Main blade is being replaced and the blade has the USB flash drive (provides secondary storage of the OSL
and the database) installed, remove the USB flash drive and set aside.
Step 2
Verify the replacement blade is the same blade type as the blade being replaced.
Step 3
Verify the software load on the replacement blade is the same as the blade being replaced.
Step 4
Open the fiber restraint gates on each side of the blade being replaced.
Note: Slide the fiber restraint gate slightly inward to open the gate.
PIU Slots
Closed
Figure 157
Unlatching Fiber Restraint Gate
Step 5
After opening the fiber restraint gates, carefully loosen the set screws on the left- and right-hand sides of the
blade, using a Phillips head screwdriver, to detach from the Housing.
·
Release 19.1.1 Issue 1.1, May 2021
Fiber Restraint
Gate
Set Screw
Open
403
Fujitsu and Fujitsu Customer Use Only