Fujitsu 1FINITY L100 User Manual page 309

System Maintenance
Trouble Clearing
Entity Type
100ME
100ME
155M
155M
1GEBT
1GEBT
·
Release 19.1.1 Issue 1.1, May 2021
Service
Severity Direction
Affected
minor non–service- n/a
affecting
Probable Cause
The SFP module is not properly seated or
has been removed.
critical service- n/a
affecting
Probable Cause
The SFP module is not properly seated or
has been removed and has an interface
provisioned on it.
minor non–service- n/a
affecting
Probable Cause
The SFP module is not properly seated or
has been removed.
critical service- n/a
affecting
Probable Cause
The SFP module is not properly seated or
has been removed and has an interface
provisioned on it.
minor non–service- n/a
affecting
Probable Cause
The SFP module is not properly seated or
has been removed.
critical service- n/a
affecting
Probable Cause
The SFP module is not properly seated or
has been removed and has an interface
provisioned on it.
Location Description
NEND Equipment Removed: TYPE=<unit type>
Suggested Corrective Action
Reseat or replace the SFP module. If a SFP module is not
required in the port generating the alarm, the alarm can be
cleared by deleting the equipment port.
NEND Equipment Removed: TYPE=<unit type>
Suggested Corrective Action
Reseat or replace the SFP module. If a SFP module is not
required in the port generating the alarm, the alarm can be
cleared by deleting the equipment port.
NEND Equipment Removed: TYPE=<unit type>
Suggested Corrective Action
Reseat or replace the SFP module. If a SFP module is not
required in the port generating the alarm, the alarm can be
cleared by deleting the equipment.
NEND Equipment Removed: TYPE=<unit type>
Suggested Corrective Action
Reseat or replace the SFP module. If a SFP module is not
required in the port generating the alarm, the alarm can be
cleared by deleting the equipment port.
NEND Equipment Removed: TYPE=<unit type>
Suggested Corrective Action
Reseat or replace the SFP module. If a SFP module is not
required in the port generating the alarm, the alarm can be
cleared by deleting the equipment port.
NEND Equipment Removed: TYPE=<unit type>
Suggested Corrective Action
Reseat or replace the SFP module. If a SFP module is not
required in the port generating the alarm, the alarm can be
cleared by deleting the equipment port.
Fujitsu and Fujitsu Customer Use Only
309