Enable/Disable Secondary Database - Fujitsu 1FINITY L100 User Manual

System Maintenance
Backup and Restore
Note: Depends on the user safety/environment requirements.
■ USB flash drive requirements:
L
Figure 166
USB Flash Drive 2.0 Dimensions
• Interface: USB 2.0 compatible
• Capacity: 4...32 GB
Note: Minimum 4 GB is required and larger than 32 GB can be used by design, but maximum 32 GB is
proved in testing.
• Minimum R/W speed: Read 20 Mb/s, write 10 Mb/s
• Maximum dimensions (W x L x H): 21.5 x 45 x 10 mm

Enable/Disable Secondary Database

The USB flash drive is enabled or disabled using the following CLI commands. The default value of usb-
secondary is enable.
Enable the USB flash drive secondary database.
Command:
% set system database usb-secondary enable
Disable the USB flash drive secondary database.
Command:
% set system database usb-secondary disable
Save the changes.
Command:
% commit
·
Release 19.1.1 Issue 1.1, May 2021
H
W
418
Fujitsu and Fujitsu Customer Use Only