UPS System Installation
4.
Remove the screws securing the corner channel and remove the channel (see
hardware for later use.
Figure 20. Section Joining
Left Top Panel
Left Middle Panel
Interior Left
Side Panel
Corner Channel
5.
Remove the screws securing the left top panel and remove the panel (see
for later use.
6.
Remove the screws securing the left middle panel and remove the panel (see
hardware for later use.
Use care during installation to protect components mounted on the right side of the ISBM section and the
intercabinet wiring harnesses attached to the left side UPM section from damage.
NOTE
52
Eaton Power Xpert 9395 UPS Installation and Operation Manual 164201764—Rev 14
Wireway Panel
Clearance between the ISBM and the UPM sections must be less than 1/2" so that
joining brackets can be installed.
Figure
UPM Section
Figure
20). Retain the hardware
Figure
22). Retain the
20). Retain the