Eaton Power Xpert 9395 Installation And Operation Manual page 24

Figure 2. Figure 1-2Power Xpert 9395 Three UPM UPS (650–825 kVA)
New Color Touchscreen Control Panel
ISBM SECTION
1 1 . . 1 1 . . 3 3 C C u u s s t t o o m m e e r r I I n n t t e e r r f f a a c c e e
• Building Alarm Monitoring– Up to five inputs in the UPS are available to connect the facility's alarm
system contacts. Some system configurations may limit the number of inputs available. The UPS uses
these inputs to monitor the building alarms in addition to the UPS status. See
for additional information.
• Alarm Contact– One alarm contact is provided for connection to equipment at the facility, such as a light,
an audible alarm, or a computer terminal. The equipment connected to this contact alerts you to a UPS
alarm. See Chapter 8 Communication
• X-Slot Communication Bays– Four communication bays are standard equipment. One to four optional X-
Slot ® connectivity cards can be installed in the UPS module at any time. X-Slot cards are quickly installed at
the front of the UPS and are hot-pluggable. See
1 1 . . 1 1 . . 4 4 A A d d v v a a n n c c e e d d B B a a t t t t e e r r y y M M a a n n a a g g e e m m e e n n t t
A three-stage charging system increases battery service life by optimizing recharge time, and protects batteries
from damage due to high current charging and inverter ripple currents. Charging at high currents can overheat
and damage batteries.
1 1 . . 1 1 . . 5 5 P P o o w w e e r r M M a a n n a a g g e e m m e e n n t t S S o o f f t t w w a a r r e e
LanSafe ® Power Management Software is bundled as part of the Software Suite CD shipped with the UPS. See
Chapter 8 Communication
for additional information.
Chapter 8 Communication
for additional information.
Eaton Power Xpert 9395 UPS Installation and Operation Manual 164201764—Rev 14
Introduction
UPM SECTION
Chapter 8 Communication
for additional information.
3