Removing And Installing Actuator Motor For Electronic Parking Brake And Handbrake - Audi A6 2005 Workshop Manual

Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
– Unscrew nuts -1-; tightening torque 10 Nm.
– Remove EPB control unit with connection -item 2-.
– Move locking slide -a- in direction of arrow -b- and unplug
connector.
Installing
Install in reverse sequence, paying attention to the following:
– When renewing the control unit, select the function "Replace"
for the relevant control unit in the "Guided Fault Finding".
Vehicle diagnostic, testing and information system - VAS 5051B-
or -VAS 5052-
11.2 Removing and installing actuator motor
for electronic parking brake and hand‐
brake
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1331-
♦ Vehicle diagnostic, testing and information system - VAS
5051B- or -VAS 5052-
Removing
Note
Ignition on
♦
Release parking brake.
♦
Coding checked and rectified if necessary
♦
Event memory interrogated, indicated faults eliminated and
♦
memory erased.
Ignition off
♦
– Raise vehicle.
126
Rep. gr.46 - Brakes - mechanism