Flash Off Time; Aiming Pointer - Datalogic QuickScan I QD24 Series Product Reference Manual

Flash Off Time

This feature specifies the OFF time for the indicator LED while in Flash Mode. The selectable range is 100 to
9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments. See
information on setting this feature.
$CSNFF
Select Flash OFF Time Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.

Aiming Pointer

Enables/disables the aiming pointer for all symbologies.
$CTAAP01(CR)
Aiming Pointer = Enable
Product Reference Guide
DEFAULT
Enter/Exit Programming Mode
page 233
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix D, Keypad
ter(s). End by scanning the ENTER/EXIT bar code again.
~
06 = Flash is OFF for 600ms
$CTAAP00(CR)
Aiming Pointer = Disable
in "References" for detailed
representing your desired charac-
CANCEL
DEFAULT
75