Table of Contents
Advertisement
Stand Mode Flash
Enables/disables the LED flash when the reader is in Stand Mode.
DEFAULT
$CSMFL01
Stand Mode Flash = Enable
Flash On Time
This feature specifies the ON time for the indicator LED while in Flash Mode.
The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100
millisecond increments. See
gramming instructions.
$CSNFN
Select Flash ON Time Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
10 = Flash is ON for 1 Second
DEFAULT
Stand Mode Flash = Disable
"Flash On Time"
on page 243 for more detailed pro-
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
Scanning Features
$CSMFL00
Appendix D, Keypad
~
CANCEL
83
Advertisement
Table of Contents
