Aiming Duration Timer - Datalogic QuickScan I QD24 Series Product Reference Manual

Enter/Exit Programming Mode

Aiming Duration Timer

Specifies the frame of time the aiming pointer remains on after decoding a label, when in trigger single mode.The
range for this setting is from 1 to 255 seconds in 1-second increments. See
description of this feature.
DEFAULT
LSTM
Set Aiming Duration Timer
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
76
page 231
LSTM00
Aiming Off After Decoding
To configure, scan the ENTER/EXIT PROGRAMMING MODE
bar code above, then the bar code at left followed by the
digits from the Alphanumeric characters in
Keypad representing your desired character(s). End by
scanning the ENTER/EXIT bar code.
~
in "References" for a
Appendix D,
CANCEL
QuickScan™ I QD24XX