Table of Contents
Advertisement
References
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The selectable range for this feature is
from 0 to 99 seconds.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc
3. Go to
page 39
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
Mode.
4. Scan the bar code: SELECT INTERCODE DELAY SETTING.
5. Scan the appropriate two digits from the keypad in
was determined in the steps above. You will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the beginning.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See
Table 34. Wedge Intercode Delay Examples
STEP
ACTION
1
Desired Setting
2
Pad with leading zero(es)
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
216
Appendix D,
Table 34
for some examples of how to set this feature.
No Delay
00
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT INTERCODE DELAY SETTING
'0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
Keypad, that represent the duration which
EXAMPLES
5 Seconds
60 Seconds
05
60
'0' and '5'
'6' and '0'
99 Seconds
99
'9' AND '9'
QuickScan™ I QD24XX
Advertisement
Table of Contents
