Scanning Active Time; Flash On Time - Datalogic Gryphon 2D Series Reference Manual

SCANNING FEATURES

Scanning Active Time

This setting specifies the amount of time that the reader stays in scan ON state once the
state is entered. The range for this setting is from 1 to 255 seconds in 1-second incre-
ments. See
$CSNET03

Scanning Active Time = 5 seconds
$CSNET08

Flash On Time

This feature specifies the ON time for the indicator LED while in Flash Mode. The select-
able range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond incre-
ments. See
Select Flash ON Time Setting
$CSNFN
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
in "References" for further description of this feature.
page 286
in "References" for detailed information on setting this feature.
page 288
ENTER/EXIT PROGRAMMING MODE
Scanning Active Time = 3 seconds
$CSNET05
Scanning Active Time = 8 seconds
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
CANCEL

10 = Flash is ON for 1 Second
represent-
PRODUCT REFERENCE GUIDE
95