Good Read Led Duration - Datalogic QuickScan I QD24 Series Product Reference Manual

Enter/Exit Programming Mode

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains on following a good read. The good
read LED on time can be set within a range of 100 milliseconds to 25,500 milliseconds (0.1 to 25.5 seconds) in
100ms increments. A setting of 00 keeps the LED on until the next trigger pull.
See page 227 in "References" for detailed instructions and examples for setting this feature.
$CLAGL
Select Good Read LED Duration Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Indicators are dimmed during sleep.
68
DEFAULT
$CLAGL00(CR)
Good Read LED Duration Setting =
Keep LED on until next trigger pull
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix D, Keypad
ter(s). End by scanning the ENTER/EXIT bar code again.
~
003 = Good Read LED
stays on for 300 ms.
representing your desired charac-
CANCEL
QuickScan™ I QD24XX