Flash On Time; Flash Off Time - Datalogic PowerScan 9500 Series Product Reference Manual

Flash On Time

This feature specifies the ON time for the indicator LED while in Flash Mode.
The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in
100 millisecond increments. See
information on setting this feature.
$CSNFN
Select Flash ON Time Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.

Flash Off Time

This feature specifies the OFF time for the indicator LED while in Flash
Mode. The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 sec-
onds), in 100 millisecond increments. See
detailed information on setting this feature.
$CSNFF
Select Flash OFF Time Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Product Reference Guide
10 = Flash is ON for 1 Second
DEFAULT
06 = Flash is OFF for 600ms
DEFAULT
Enter/Exit Programming Mode
page 283 in "References" for detailed
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
~
CANCEL
page 284
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
~
CANCEL
repre-
in "References" for
repre-
75