Ack Character; Nak Character - Datalogic QuickScan I QD24 Series Product Reference Manual

Enter/Exit Programming Mode

ACK Character

This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII characters or any hex
value from 0 to 0xFF can be selected. See
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with normal
operation of these characters. 8-bit data is not recognized when the option
7 Data Bits.
$CR2AC
Select ACK Character Setting

NAK Character

This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII characters or any hex
value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with normal
operation of these characters. 8-bit data is not recognized when the option
7 Data Bits.
$CR2NA
Select NAK Character Setting
28
page 208
DEFAULT
See page 209
DEFAULT
for more information.
0x06 'ACK' Character
for more information.
0x15 'NAK' Character
Data Bits
has been set as
Data Bits
has been set as
QuickScan™ I QD24XX