Table of Contents
Advertisement
References
Keyboard Interface
Wedge Quiet Interval
Specifies the amount of time the reader looks for keyboard activity before it breaks the keyboard connection in
order to transmit data to host. The range is from 0 to 990ms in 10ms increments.
This feature applies ONLY to the Keyboard Wedge interface.
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with leading zeroes to yield
two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3. Go to
page 39
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Prog. Mode.
4. Scan the bar code: SELECT WEDGE QUIET INTERVAL SETTING.
5. Scan the appropriate two digits from the keypad in
was determined in the steps above. You will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to abort and not save
the entry string. You can then start again at the beginning.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit.
This completes the procedure to set the Wedge Quiet Interval. See
feature.
Table 32. Wedge Quiet Interval Setting Examples
STEP
ACTION
1
Desired Setting
Divide by 10 (and pad with
2
leading zeroes)
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
214
Appendix D,
10ms
01
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT WEDGE QUIET INTERVAL SETTING
'0' and '1'
Scan ENTER/EXIT PROGRAMMING MODE
Keypad, that represent the duration which
Table 32
for some examples of how to set this
EXAMPLES
150ms
600ms
15
60
'1' and '5'
'6' and '0'
850ms
85
'8' and '5'
QuickScan™ I QD24XX
Advertisement
Table of Contents
