Stand Mode Illumination Off Time; Scanning Active Time - Datalogic QuickScan I QD24 Series Product Reference Manual

Stand Mode Illumination Off Time

Specifies the amount of time reader illumination stays off after pulling the trigger when in Stand Mode. The
configurable range is 01 to 32 by 01 in increments of 500ms (500ms to 16 seconds). See
for a description of this feature.
$CSNTM
Select Stand Mode Time Setting

Scanning Active Time

This setting specifies the amount of time that the reader stays in scan ON state once the state is entered. The range
for this setting is from 1 to 255 seconds in 1-second increments. See
description of this feature.
$CSNET05(CR)
Scanning Active Time = 5 seconds
Product Reference Guide
DEFAULT
Enter/Exit Programming Mode
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix D, Keypad
representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code again.
04 = 2 Seconds
page 230 in "References" for further
$CSNET03(CR)
Scanning Active Time = 3 seconds
DEFAULT
$CSNET08(CR)
Scanning Active Time = 8 seconds
page 229 in "References"
73