Table of Contents
Advertisement
References
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state once the state is entered. The range
for this setting is from 1 to 255 seconds in 1-second increments.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20 = 020, etc.
3. Go to
page 73
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
Mode.
4. Scan the bar code: SELECT SCANNING ACTIVE TIME SETTING.
5. Scan the appropriate three digits from the keypad in
was determined in the steps above. You will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the beginning.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See
Table 39. Scanning Active Time Setting Examples
STEP
ACTION
1
Desired Setting
2
Pad leading zero(es)
3
4
Scan Three Characters From
5
Appendix D, Keypad
6
230
Table 39
for some examples of how to set this feature.
1 Second
001
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT SCANNING ACTIVE TIME SETTING
'0' , '0' and '1'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D,
Keypad, that represent the duration which
EXAMPLES
90 Sec. (1.5 min.)
180 Sec. (3 min.) 255 Seconds (4.25 min.)
090
'0' , '9' and '0'
'1' , '8' and '0'
180
255
'2' , '5' and '5'
QuickScan™ I QD24XX
Advertisement
Table of Contents
