Enter/Exit Programming Mode
Stand Illumination Control
Controls the illumination status while the reading mode is stand mode and the reader is
attempting to detect objects.
DEFAULT
$CSMIL01(CR)
Stand Illumination Control = ON
Flash On Time
This feature specifies the ON time for the indicator LED while in Flash Mode. The selectable
range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments. See
page 258
in "References" for detailed information on setting this feature.
$CSNFN
Select Flash ON Time Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
80
10 = Flash is ON for 1 Second
DEFAULT
$CSMIL00(CR)
Stand Illumination Control = OFF
$CSMIL02(CR)
Stand Illumination Control = Dim
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
Appendix D, Keypad
acters in
desired character(s). End by scanning the ENTER/EXIT
bar code again.
~
QuickScan™ I QD24XX/QBT24XX/QM24XX
Scanning Features
representing your
CANCEL