Resetting The Product Configuration To Defaults - Datalogic QuickScan I QD24 Series Product Reference Manual

Resetting the Product Configuration to Defaults

Restore Custom Defaults
If you aren't sure what programming options are in your imager, or you've changed some options and want to
restore the Custom Default Configuration that may have been saved in the scanner, scan the Restore Custom
Default Configuration bar code below. This will restore the custom configuration for the currently active interface.
Custom defaults are based on the interface type. Configure the imager for the correct
interface before scanning this label.
$P,HA00,P(CR)
Restore Factory Configuration
If you want to restore the Factory Configuration for your imager, scan either the Restore USA Factory
Configuration bar code or the Restore EU Factory Configuration bar code below. Both labels restore the scanner
configuration to the factory settings, including the interface type. The USA label restores Label IDs to those
historically used in the USA. The EU label restores Label IDs to those historically used in Europe. The Label ID
sets for USA and EU are shown in the
The programming items listed in the following sections show the factory default settings for each of the menu
commands.
Product Reference Guide
Restore Custom Default Configuration
"Label ID Control" section on page 53
$P,AE,P(CR)
Restore USA Factory Configuration
$P,Ae,P(CR)
Restore EU Factory Configuration
Customizing Configuration Settings
of this manual.
13