Configuration Using Bar Codes; Configuration Parameters - Datalogic QuickScan I QD24 Series Product Reference Manual

This and following sections provide programming bar codes to configure your reader by changing the default
settings. For details about additional methods of programming, see
You must first enable your reader to read bar codes in order to use this section. If you have not
done this, go to

Configuration Parameters

Once the reader is set up, you can change the default parameters to meet your application needs. Refer to
Defaults" starting on page 245 for initial configuration in order to set the default values and select the interface for
your application.
The following configuration parameters are divided into logical groups, making it easy to find the desired function
based on its reference group.
Interface Configuration:
• "RS-232/USB-Com Interfaces" on page 24
• "Keyboard Settings" on page 33
Parameters common to all interface applications:
• "Data Format" on page 47
• "Reading Parameters" on page 61
Symbology-specific parameters:
• "1D Symbologies" on page 81
their options.
• "2D Symbologies" on page 173
their options.
You must first enable your reader to read bar codes in order to use this section. If you have not
done this, go to
To program features:
1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of each programming page, when
applicable.
2. Scan the bar code to set the desired programming feature. You may need to cover unused bar codes on the
page, and possibly the facing page, to ensure that the reader reads only the bar code you intend to scan.
Product Reference Guide

Configuration Using Bar Codes

Setup, starting on page 5
gives options to control the messages sent to the Host system.
control various operating modes and indicators status functioning.
provides configuration of a personalized mix of 1D codes, code families and
provides configuration of a personalized mix of 2D codes, code families and
Setup, starting on page 5
"Configuration Methods" on page
and complete the appropriate procedure.
and complete the appropriate procedure.
Chapter 3
4.
"Standard
15