Connecting To Bluetooth Obd Ii Dongle - Teltonika FMB1YX User Manual

 When device configuration is loaded press „Bluetooth" settings (Figure 46 1
position).
 Turn on BT Radio by pressing „Enable (visible)" (Figure 46 2 position). "Local name"
(Figure 46 3 position) automatically will be "FMB1YX_last 7 imei digits", you can
leave it or type your own name.
 Set Security Mode (Figure 46 4 position) to "PIN only" or "None" (you could select
"PIN + MAC list" or "MAC list only" security mode but in this case you need to type
external device MAC address in "Authorized Devices MAC List" (Figure 46 7
position).
 Set connection mode to "OBDII" (Figure 46 5 position).
 Set „External Name" as your Bluetooth OBD II device name for proper device
identification and connection to it. In this example OBD II device name is „DONGLE"
but at least 2 characters are needed to recognize it and connect to it. For better and
faster adapter identification in network you could enter a full device name. You
could check your OBD II adapter Bluetooth name by scanning nearby Bluetooth
devices using mobile phone or computer with Bluetooth adapter.
 Go to "OBD II (Bluetooth)" in left menu and select priority and others parameters
visible at Figure 47.
 After all these steps press „Save to device" to save configuration (Figure 46 8
position).
 Now you can disconnect FMB device from a configurator.

Connecting to Bluetooth OBD II dongle

5.16.5.2
After this configuration you could connect your car OBD II dongle to FMB device. Turn on
ignition then turn on its Bluetooth connection. For pairing follow your dongle instructions
1
OBD II dongle Bluetooth connection pairing instructions depends on specific model.
Figure 47 OBD II Bluetooth settings.
1
. OBD
70